Fabric Covering Wing 2 of 8

Fabric bottom wing B

With the wing turned upside down, the first length of fabric was draped over and glued on the trailing edge with a one inch glued turnover section on the topside of the wing. The bottom trailing edge of the Northstar Wing incorporates a very gracefully formed “S” shaped aluminum profile. The fabric in the “S” shaped profile must be glued down along it’s entire shape otherwise the fabric would stretch across the curves after shrinking. Before gluing down the trailing edge, the fabric was precisely cut out to fit over the large aileron and flap protrusions.  Also, prior to gluing the fabric down, a pencil centerline was drawn on the leading edge where the top and bottom pieces of fabric would eventually meet and overlap each other for a glued two inch overlap. After the trailing edge fabric was attached and dried,  glue was then applied on numerous edges where inspection covers occurred and around the tank cover openings. The photos above show the fabric as it was glued over these edges. Please note the fabric is loose and was not shrunk down yet. Poly Fiber instruction suggest one inch of fabric slackness after the fabric is glued down prior to shrinking.  On the upper left photo there is a protrusion that was not cut out. This is an eye bolt used for a flying rope connection for the aircraft when on floats.  The protrusion was only an inch or so above the surface allowing the fabric to be cut out after the fabric was shrunk.

While the fabric attachment was fairly routine on the trailing and leading edges it was quite different on the wing tip edges.  This was especially true on the compound curves where fabric would otherwise bunch up. To avoid this, the iron was heated up to a low heat setting and the fabric was dry formed (without glue) which included clamping, heating the fabric, pulling the fabric around and repeating this until the fabric was shaped to follow the curve.  Excess fabric was then trimmed away and the fabric was clamped and glued in place until dry.

Before starting on the topside of the wing, you use your iron on the fabric edges where the bottom and top fabric glued edges will overlap to take out any wrinkles or imperfections.

Check out our Clear To Land Store;

http://www.zazzle.com/clearedtoland

 

 

Advertisements

Covering The Fuse & Turtle Deck

Image

 Attaching large sheets of sticky medium weight Polyester fabric to the sticky Poly Tak edges of the fuselage frame became a two person job.  The objective is to attach the fabric before the Poly Tak glue starts to set up and dry while also leaving enough time to get the right amount of slack in the fabric for shrinking allowance. Too little slack could deform the metal frame during shrinking and too much slack could result in a saggy skin.

Side walls of the fuse were covered first, then shrunk and trimmed. The Belly panel was attached next and overlapped the side walls. The roof panel was attached last.  Fabric tapes were attached on the edges and over the stringers using Poly Brush as the glue.  Poly brush coats were then brushed on next over the entire fabric surface.  Poly Brush coats were then sprayed on as seen in the photos above.

The Turtle deck had its own spray booth and is shown with tapes attached.  There is no “Red Tint” on the fabric finish since the “Untinted Poly Brush was used.

The next step will be the Silver Coats using  Poly Spray for UV Protection.