The sides of the Turtle Deck were fabric covered first and heat shrunk and then the top fabric was attached and shrunk down. The above photo shows the fabric before tapes were attached. Because the inside of the Turtle Deck can be seen when it is raised, I used the “Untinted” Poly Brush which is basically a clear finish product. The regular Poly Brush has a red tint and as you brush it on before, during and after the taping stage the brush marks and runs all begin to show. The red tint is there so you can see where you have brushed and where you haven’t. Theses brush marks will all be coated over with the sprayed on silver and color finishes but they will always be seen from the back side of the fabric. That’s not a problem when it’s inside the fuselage and can’t be seen but any fabric that can be seen from the back side such as fabric that faces the cockpit or in my case is seen when the turtle Deck is raised is an area where you would want to use the “Untinted” Poly Brush product